Smittybilt 76742 Front Bumper User Manual download pdf

WWW.SMITTYBILT.COM

For Technical Support/Warranty Information please call 310-762-9944

Smittybilt, 400 West Artesia Blvd, Compton, CA 90220

Installation Instructions

07-09 JK Front Bumper

Part# 76722,76805,76741,76742

Parts Included Qty Parts Included Qty

12 x 35mm Hex Head Bolt 2 12 mm Flat Washer 12

12 x 35mm Carriage Bolt 4 12 mm Lock Washer 12

12 mm Nut 10

Step 1: Remove your front factory bumper. On certain bumpers you may need to remove your factory

front plastic frame cover. (Before taking bumper off, make sure you have disconnected the fog

lights)

Step 2: Drill out the top outer hole in the front frame mounting plates to ½’ (Fig A, B)

NOTE: Due to some variances you may be required to drill out the holes to ¾”. After

drilling the holes to ½” hold bumper up to frame. If all of the threaded studs don’t line up,

Carefully lay bumper to side and drill holes to ¾” Use caution when drilling

(Fig A) (Fig B)

Step 3: Position the bumper up on the front of your jeep by aligning the welded studs on the bumper into

the holes on the front frame mounting plates. Secure studs using 1 ea flat washer, lock washer and

nut. Insert 12 x 35 mm hex bolt with 1 ea flat washer and lock washer in the reaming two holes.

(Fig B) Level the bumper and then proceed to tighten all bolts to 60 ft.lbs

NOTE: carefully read entire instructions before attempting to install this product.

It is recommended to have assistance while lifting and installing the bumper.

Drill this

hole to ½”

Drill this

hole to ½”

1 2 3

WWW.SMITTYBILT.COM For

Page 2

WWW.SMITTYBILT.COM For

Page 3

WWW.SMITTYBILT.COM For

No comments

Smittybilt 76742 Front Bumper User Manual