For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Sure Steps (Part # CN012-S4)
1992-1999 Suburban 4 Door
QTY PART # DESCRIPTION
1 CN012-S4L Sure-Step, left side
1 CN012-S4R Sure-Step, right side
1 603722 hardware kit
1 720009 warranty statement
NOTE: Please read this information before installing. Check components received with components listed above. NO
DRILLING REQUIRED for installation of these Sure-Step side bars. To obtain correct installation, we recommend
you to follow these step by step installation instructions carefully. Please take care when installing this product to
protect the finish and your investment. For Technical Support please call (951) 736 8686.
Step One: Locate hardware marked 603722. Check contents of 603722 with the hardware listed below.
QTY PART # DESCRIPTION
2 901119 12mm x 1.75mm x 120mm hex bolts
6 901011 1/2 flat washers
6 901012 1/2 split lock washers
4 000000 1/2-13 x 2” hex bolts, GR.5
2 901132 2 1/2 od. spacers, zinc plated
4 #30 3” plastic rings
1 801086L front support bracket, left side
1 801086R front support bracket, right side
1 801357L rear support bracket, left side
1 801357R rear support bracket, right side
Step Two: Locate the CN012-S4L side bar, one 801086L support bracket, one #30 plastic ring, two ½ x 2” hex bolts, two
½” flat washers and two ½” split lock washers. Secure the bracket and ring to the side bar using the hardware
listed in this step. (Fig #1) Do not fully tighten hardware at his time. Repeat this procedure on the other end of
the side bar using the 801357L support bracket.
Step Three: Locate one 901132 spacer, one 12mm hex bolt, two ½” flat washers and one ½” split lock washer. Remove the
front cab mount bolt located under the cab. Remove the rear spring hanger nut. “CAUTION” do not remove
the rear spring hanger bolt, doing so could result in injury or damage to the vehicle. Place the spacer over
the spring hanger bolt and position the rear support bracket over the rear spring hanger bolt. Secure the support
bracket and spacer to the spring hanger with the factory nut as shown in fig #2. Do not fully tighten the nut at
this time. Position the front support bracket under the front cab mount. Secure the support bracket to the bottom
of the cab mount as shown in fig #3 using the remaining hardware listed in this step. Fully tighten all hardware
at this time. Torque part 901119 to 50 ft. lbs., 901030 to 30 ft. lbs. and the rear spring hanger nut to 80 ft. lbs.
Comments to this Manuals