WWW.SMITTYBILT.COM
For Technical Support/Warranty Information please call 310-762-9944
Smittybilt, 400 West Artesia Blvd, Compton, CA 90220
Installation Instructions
Front Euro Turn Signal Guards
Part # 5690
07-11 Wrangler & Unlimited
Turn Signal Guard 2
Step 1: Remove front turn signal lights, by first disconnecting the wire loom plug (Fig A) by pulling out
the red tab and pushing down on clip.
Step 2: Push in the center pin on each of the two clamps that hold the turn signal on the grille. (Fig B)
You may then pull the turn signal out from the front.
Step 3: Line the three tabs on the light guard with the plastic extrusions on the side of the turn signal (Fig C)
It may be easier to slightly bend one tab outward in order to connect the other tabs, once done
simply push remaining tab on. (Fig D)
(Fig A) (Fig B)
(Fig C) (Fig D)
Note: Read instructions entirely before installing this accessory.
Comments to this Manuals